Business Hours: Monday - Friday, 7:30am - 4:00pm [Closed Saturday / Sunday]
In stock
2018-22 Mustang 10R80 1500HP Carbon Drive Shaft
$3,056.97 NZD
These REV™ Series carbon fiber driveshafts are direct bolt-in. Designed and wound specifically for S197 and S550 Ford Mustangs, they feature the same high-quality materials and benefits as the rest of our REV™ Series driveshafts and are available for the following applications:
Engineered for up to 1500 HP with a max rated torque of 1000 lb*ft, QA1's Mustang driveshafts feature Spicer Life Series 1350 U-joints and utilize a high-speed CV joint with a high-speed sealing boot and high-temp grease. This high-speed capability allows us to minimize the effects of NVH while increasing performance.
What makes QA1's driveshaft the best?
The Mustang driveshafts are designed for stock vehicles. Any modifications can affect fitment. Please refer to the length specifications from the tube end to the CV joint shown in Table 1 in the installation guide to confirm that the driveshaft will have the correct fitment for your vehicle.
This product has been designed, manufactured and balanced to the highest standards and is intended for use in maximum-performance applications where increased safety and vehicle performance are primary considerations. As a result of converting from an isolated two-piece driveshaft design, it may be possible for an increase in NVH (noise, vibration, and harshness) to occur in certain operating conditions.
To minimize this possibility, ensure that all mounting surfaces are completely clean and free of any burrs during installation. To minimize NVH, you may try rotating the installed position of the driveshaft relative to the transmission flange 180 degrees. Given that the driveshaft is part of the engine-transmission-rear axle system, minimizing NVH is an install and evaluate process.
Ways to pay
Pre-Purchase
Ship with confidence
