Available for the 2017 Jeep Trackhawk.
852 bhp (635kW) @ 6,200 rpm*
1145 Nm torque @ 4,200 rpm
High flow air induction system
Lower pulley upgrade (increases boost to 14 psi)
All necessary gaskets and fluids
Chassis dyno testing and tuning
Hennessey embroidered head rests
Exterior Hennessey emblem
Exterior HPE850 emblems
Serial numbered dash plaque
Serial numbered plaque in engine compartment
Platinum synthetic oil & filter change
Call CTB Performance or full out the sheet below for pricing and turnaround time details
* Estimated power ratings at the engine. Actual power will be measured at the rear wheels, before and after the upgrades are installed and tuned. Rear wheel horsepower and torque figures are approximately 15-20% lower than the factory published power figures which are measured at the crankshaft on an engine dyno.